Unfortunately, I don't live in a Windows world but need something I can access over the network. For a Crestron setup, the typical interfaces are the Crestron hardware devices (touchpanel, remote, etc) or Xpanel (ActiveX on Windows, Application on Windows). Discussion Starter 1 Dec 6, 2007.

DMC-4K-HDO output card doesn't support HDR.рџ”„ DMC-4K/4KZ-DSP cards do not down-mix DTS:X or Dolby Atmos audio to PCM 2ch audio.рџ”„ DMC-4KZ-HD(-DSP) card setup with DM default 4k 60Hz 2CH/HBR EDID may produce unstable video when connected to certain streaming or Blu-ray players.рџ”„ Assigning Global EDID via DM Tool to fully populated DM-MD32x32 chassis may report false failures. The route should be re-established after the endpoint is onlineрџ”„ DM-MD8x8/16x16/32x32-CPU3(-RPS) doesn't support connecting LAN port and Content LAN port to the same subnet.рџ”„ Vertical bezel compensation value set from the DM Tool doesn't persist across reboot for DM-RMC-4KZ-SCALER-C, instead set the value programmatically when desired.рџ”„ When routing same to more than 8 DMC-4KZ-HDO outputs in DM-MD16x16/32x32-CPU3(-RPS), sporadically some outputs don't have freeze-frame switching.рџ”„ When Audio Breakaway is enabled, DM-MD32x32-CPU3 switcher may take additional 15-20 seconds for audio to recover compared to video post reboot.рџ”„ Routing an to all outputs in DM-MD32x32-CPU3 switcher may observe audio double lock during switching on DMC-4K-HDO and DMC-4KZ-HDO outputs.рџ”„ DM-MD8x8/16x16/32x32-CPU3(-RPS) web-based XPanel configuration tool doesn't have redundant power supply status.рџ”„ DM-TX-4KZ-302-C DisplayPort doesn't work reliably with USB-C to DisplayPort cables and adapters.рџ”„ TT-100 'Connect It' indicators don't work when connected to USB HID port of the DM-TX-4KZ-302/202-C, instead use COMPUTER port on the TX if necessary.рџ”„ Audio_Format_fb, Audio_Channel_fb and Audio_Sampling_Freq_fb joins don't work for DMCI-DMC-4KZ-C/-DSP and DMCI-DMC-4KZ-HD/-DSP symbols.рџ”„ When switching upstream, 4K/4KZ outputs may have double audio lock with certain LG/Samsung Blu-Ray players.рџ”„ When HDR source is routed to DMC-4K-HDO output card, instead of no video it may output bad video depending on I/O signal video resolution. Wall configuration can be recovered by resending the configuration values from Crestron SIMPL/C# program after chassis has been restarted.рџ”„ DM-MD8x8/16x16/32x32-CPU3(-RPS) doesn't support connecting LAN port and Content LAN port to the same subnetрџ”„ DM-TX-200-C-2G HID routing may not survive a switcher reboot.

Crestron Xpanel Port